We handle custom fabrication and product installation at Mayhem Metal Works. Anything from a small welding job to a full vehicle builds!
Rear Link Suspension Kit
79-95 Toyota Pickup & 4runner
$1500.00
We have heard from a lot of people wanting to only link their rear suspension so we created a kit using the back half of our full link kit. You still get all of the benefits of our subframe and removable skid plate design but you have to do a little more work to get it. We provide you with the hard part of the removable skid plate where it ties into the rear of the subframe and rear lower link brackets, you just need to continue the skid plate forward to connect to your transfer case crossmember.
The kit includes everything you need to link the rear of your truck other than shocks/springs, upper shock mounts, bump stops, and limit straps. Link tubes are provided extra long and will allow the rear axle to be pushed back up to 6”
The bottom of the subframe hangs 5” below the frame rails which is about the same as most aftermarket transfer case crossmembers. Because of this you get great anti-squat/roll axis geometry and unlike other kits on the market you do NOT have to cut your floor/bed out to make room for the upper link mounts.
Includes the following parts:
1 Rear subframe with removable center section/frame end link mounts
2 Rear axle lower link brackets
1 Rear axle upper link bracket assembly
2 Rear lower shock mounts
4 1¼” Heim joints/jam nuts/tube bungs
4 7/8” Heim joints/jam nuts/tube bungs
2 lower link tubes
2 upper link tubes
1 Grade 8 hardware kit
Important notes about this kit:
• Requires relocating your gas tank
• Recommended for use with wider “IFS” rear axle
• Part of the subframe mounts to the factory crossmember that goes over your rear diveshaft, If this crossmember has been removed from your vehicle a suitable replacement will need to be added.
• This kit requires welding that is critical to the safety of your suspension. All welding must be done by a qualified welder.
• Recommended for off-road use only.
Our team at Mayhem Metal Works ranges from some of the best 4×4 Rock Crawling experts, Drag Car Racers to engineers from the highest scientific achievements. We’ve sent things to space and back! It’s safe to say we know our fabrication.
Contact us to book you project.
SERVICES INCLUDE
Assembly & Installation of Our Products
Custom Suspension Design & Fabrication
General Metal Fabrication
Vehicle Preparation
Welding (MIG & Tig)
Plasma Cutting
Tube Bending
Roll Cages
Bumpers
Electrical / Wiring
Vehicle Fluid System Plumbing
CUSTOM WORK PERFORMED ON
Rock Crawlers
4x4’s
Street Rods
Imports
Most Vehicle or Non Vehicle Metal
Fabrication